The PHEV manual includes an emergency response guide for rescuers. The key information is summarised here so you can pass it on if needed.
Warning:The steps on this page are for qualified rescuers and technicians. Rescuers must wear basic protective equipment and, depending on the situation, high-voltage or fire protective equipment. Ignoring this can cause injury or death.
Vehicle data
| Item | Value |
|---|---|
| Length / width / height | 4,500 / 1,865 / 1,670 mm |
| Wheelbase | 2,672 mm |
| Max. total weight | 2,210 kg |
| Seats | 5 |
| Power battery type | Lithium-ion |
| Battery pack nominal voltage | 339.2 V |
| Battery pack rated capacity | 54 Ah |
| Cell nominal voltage / capacity | 3.2 V / 54 Ah |
| Number of battery packs | 1 |
| Fuel tank capacity | 60 L |
Disconnecting the 12 V battery
- 1Switch the vehicle to the power-off state using the power button on the quick menu screen.
- 2Open the boot, lift the flip cover on the right of the luggage compartment, and disconnect the 12 V battery negative cable.
Shutting down the high-voltage system
- 1Switch the vehicle to the power-off state.
- 2Disconnect the 12 V battery negative cable in the boot.
- 3Remove the front compartment fuse box cover. Using the layout on the cover, pull out the BMS fuse with a fuse puller to cut power to the BMS module.
Releasing a locked charging cable
The charging cable locks automatically while charging or when the doors are locked, and unlocks when you unlock the doors. If it isn't removed within 2 minutes it locks again – press unlock on the key to release it.
- 1If the lock is faulty: check on the instrument cluster that the car is not charging or discharging.
- 2Open the tailgate, lift the boot carpet and remove the storage box.
- 3Pull the electronic lock release cable to unlock the charging/discharging cable.
Parking and lifting
- Press the brake fully and press P on the shift lever – the electronic parking brake applies automatically.
- Only lift the car at the correct jacking points, so you don't damage high/low-voltage cables or the power battery.
Opening the back door with a flat battery
- 1Stop the car as safely as possible.
- 2Fold down the rear seatback.
- 3Climb into the rear and open the emergency release cover.
- 4Press the emergency switch and push the back door open.
Caution:Rescuers must not cut through high-temperature or high-voltage areas (airbag parts, fuel parts, high-voltage components). The pillars are cast aluminium – use proper tools such as hydraulic cutters.